SPECIFICATION FOR QUAD 33 CONTROL UNIT
| Distortion: |
All controls level, 0.5V rms output, with any input. |
0.02% 0.1% |
30- 10kHz |
| Residual Noise: | 0-30 phon weighting ls'7kHz bandwidth controls level or cancel | -90Db | |
| Freq. Response: | Any input, any output RIAA or flat as appropriate | +/-0.5dB 30-20kHz |
|
| Tone Controls: |
+/- ldB of published curves |
||
| Filters: | To pubtished curves @ 5ktlz,7kHz, l0kHlz +/-5% | ||
| Inter channel balance: | Within 1dB with volume control varied from maximum to -45db | ||
| Balance Control Range: | 9dB either way | ||
| Crosstalk: | Dependant on input source impedances. Replay / record typically better than 70dB 30-10,000 Hz Interchannel typically better than 40dB 30-10,000 llz |
INPUTS (all voltages rms)
1 2 3 4 Signal to noise 20K ohms or less 100K ohms 100mV 2V 85dB any 40K ohms 1V 10V 85dB any 40K ohms 400mV 4V 85dB any 40K ohms 100mV 1V 85dB Low Output Magnetic 0.5-2mV/Cm/Sec. 68K ohms 2mV @ 1kHz 40mV @ 1kHz 70dB High Output Magnetic 1.5-6mV/Cm/Sec. 68K ohms 5.6mV at 1kHz 120mV at 1kHz 80dB Ceramic Special 100mV @ 1kHz l.2V @ 1kHz
Recommended Source
Impedance
Load Impedance
Input level for 0.5V
Main Output
Max
Input
referred to level in Col 3
0-30 phon weighting
Radio:
Tape
Replay H
M
L
Disc
M1
M2
C1
450-800pF
2l80mv/cm/Sec.
S
FOR SPECIAL REQUIREMENTS
OUTPUTS (all voltages rms)
|
Level |
Source |
Recommended |
Max. Cable Lengtbs - |
||
| To Power Amp |
0.5V |
100K ohms |
10K ohms or over |
100 feet |
|
|
H |
100mV * |
5K ohms |
25K ohms or over |
150 feet |
|
| To Tape Recorder |
M |
20mV * |
800 ohms |
any |
any |
|
L |
3.7mV * |
180 ohms |
any |
any |
|
* 30% programme modulation |
| Weight | 6.5 lb (3kg) | |
| Dimensions | Width | l0.5" (260mm) |
| Height | 3.6" (92mm) free stalrding, 3.25" (83mm) panel | |
| Depth | 6.5" (l65rnm) free standing 5,5" (l40mm) behind cabinet panel when mounted (Allow a further 2.5" (64mm) beyond rear panel for connectors) |
|
| Power Input: | 100-130 / 200-260V 50-60 Hz 1.5 Watts. |